29
28
2b
3
2a
Section 8: Installing the Performance
Crossover Rear-Facing
WARNING!
DEATH or SERIOUS INJURY
can occur
1. Ensure the base is properly
installed and there are no
objects on top of the base.
2. Face the seat toward the rear of
the vehicle and place the seat
into the base. Pull up on the seat
to verify that all four attachment
rods are secured to the seat.
3. After initial connection to the
base, the seat will be at its
upmost position. Recline the
seat by pulling on the recline
lever so that the level to ground
line on the side of the seat is
parallel with the ground.
3. While pressing the base firmly
into the vehicle seat near the
belt path, pull the vehicle seat
belt to remove any slack.
The base is secure when it
cannot be moved more than
1
inch (2.5 cm)
in any direction at
the belt path
.
4. Slide the shoulder belt into
the lock off after the slack is
eliminated.
3
4
REAR-F
ACING
Installation
Base Installation - Non-Locking ELR Lap/Shoulder Belt