© 1995-2010 ReChargX, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the ReChargX and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
TonerRefillKits.com
Mon - Fri 8am - 5pm ET
800.527.3712 or 352.343.7533
RechargX RX163
2010.07.12
Page 7
Step 14: Waste Hopper Hole Location
The waste hopper hole will be placed on the
bottom-left side of the cartridge, as shown by
the white circle in figure 15.
Step 15: Create the Waste Hopper Hole
Plug in the hole-making tool included with the
ReChargX Tool Kit.
Wait the full 3 minutes (as indicated using the
sand timer). Allowing the tool to heat up for
3 minutes will ensure the tool is hot enough to
penetrate the cartridge more easily.
Hold the ReChargX hole-making tool directly
over the location for the hole and press the
copper hole-making bit against the cartridge
allowing the heat of the tool to create the
hole (there is no need to use excessive force,
let the tool do the work with a minimal
amount of pressure), as shown in figure 16.
Note:
Once the copper tip of the hole-making
tool slowly penetrates the top of the toner
cartridge, immediately withdraw the tool and
unplug it from the wall.
Step 16: Remove the Excess Plastic From
the Hole-Making Tool
Using the tip of the flat-blade screwdriver,
included in the ReChargX Tool Kit, remove the
small piece of plastic from the copper tip of
the hole-making tool, as shown in figure 17.
This small piece of plastic is impossible to
remove once it becomes cold and hardens to
the copper tip of the hole-making tool.
Figure 15
: Locate the toner waste hopper
Figure 16
: The waste hopper hole
Figure 17
: Removing the excess plastic piece
