© 1995-2010 ReChargX, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the ReChargX and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
TonerRefillKits.com
Mon - Fri 8am - 5pm ET
800.527.3712 or 352.343.7533
RechargX RX163
2010.07.12
Page 8
Figure 19
: Cleaning the waste hopper hole
Figure 18
: Emptying the waste toner
Step 17: Empty the Waste Toner Hopper
Now we will remove the waste toner from the
toner cartridge.
Note
: This toner cannot be used again as
paper, dust, hair, staples and other small items
can accumulate in the waste hopper.
Holding the cartridge over the newsprint,
included in the ReChargX Tool Kit, carefully
pour out any waste toner, as shown in fig. 18.
If the waste toner stops flowing, stand the
cartridge up again and then re-lower the hole
over the paper (gently tapping along the side
of the toner cartridge helps to keep the toner
flowing as well).
Note
: There is no need to attempt to remove
every last bit of waste toner from the hopper,
just that which comes out easily.
Step 18: Clean the Area Around the
Waste Hopper Hole
After the waste toner has been removed from
the waste hopper, use the yellow/orange
toner grabber cloth to clean around the waste
hopper hole, as shown in figure 19, so the
ReChargX leak-proof seal will adhere to the
cartridge body as completely as possible.
