42
TRAINING PREARRANGEMENTS
Ad
justment of rotary arm with pedals:
Before positioning the unit to
the bed you need to adjust the rotary
arm with pedals
3
. When training
takes place from the foot part of the
bed, the rotary arm needs to be pivoted
into the cycling direction.
Depending on right or left side application, the rotary arm needs to
be adjusted to the right or left side, adapting to the user's position. To
adjust the rotary arm to a required position, unscrew the thumb screw
4
and pull the bolt
5
. Now you can adjust the rotary arm
3
to the
desired position. The bolt
5
will snap back in automatically and the
rotary arm
3
will be in place. Retighten the thumb screw
4
. Set the
knee bending adjustment into start position using the manual thumb
wheel
6
(fig. 40)
.
Attaching to the bed unit:
Positioning the MOTOmed letto2 in front
of the bed unit. Unfasten the fixation
screw of the height adjustment
7
and pump up the rotary arm using the
foot pedal of the hydraulic height
adjustment
8
.
Adjustment of the track gauge:
If the track gauge of the MOTOmed
chassis is too tight to ride under the bed you can adjust the width with
the Allen key or up to 30 cm.
With the accessory
Expandable Chassis (item no. 160.000)
you can
do adjustments without tools.
For security reasons, constricting the track width inward on the
MOTOmed letto2 leg/arm model is not possible.
fig. 38
7
8
fig. 39
page 57
