RECKE
MULTICOOKER
MC-X160
Lift the front side of the device if needed, to let the condensate flow into the reservoir.
Gently grasp the sidewall of the reservoir and softly pull it toward you to remove it.
Pour out the condensate and clean the reservoir.
After cleaning, set the reservoir back in place.
Sometimes, excess condensate can accumulate in a special recess on the body of the
appliance. Use a kitchen towel or napkin to remove it.
Error code
Possible malfunction
Solution
Е1 –
Е3
System error (possible failure
of the circuit board or the
heating element), the lid is
not tightly sealed or
automatic overheat
protection is activated.
Do not switch on the appliance with the empty bowl!
Unplug the appliance from the socket and let it cool off for 10-
15 minutes. Afterwards, pour some water (broth) into the
bowl and resume cooking.
Seal the lid tightly.
If the problem persists, contact the authorized service center.
Malfunction
Cause
Solution
Unable to switch on
the appliance
The multicooker is disconnected from
the power source
1.
Check the availability of electricity
2.
Check whether the multicooker is
correctly plugged into a wall
socket
Raw dish or it takes
too long to cook
1.
Cooking time is too short
2.
Foreign object between a bowl
and the heating element
3.
Misplaced cooking bowl
4.
Heating element malfunction
1.
Extend the cooking time
2.
Unplug the appliance, let it cool
off and remove the foreign object
3.
Properly place the bowl
4.
Contact Authorized Service
Centre
Auto-heat mode not
working
Heat maintenance elements
malfunction
Contact Authorized Service Centre
Tingling electric shock
when touching the
body of the appliance
Electricity leakage
1.
Please connect multicooker to the
grounded electricity socket, to
prevent damage on product and
electric shock, fire
2.
Contact Authorized Service Centre
37