Technical data:
power supply 230 volts / 50 Hz or 110 volts / 60 Hz
input sensitivity 0.1 - 10 volts / 10 k ohms
all signal output 3 volts
satellite frequency response 50 - 40000 Hz -1 dB
satellite high pass, stereo, variable
50 - 150 Hz / 24 dB
satellite total distortions
0.001 %
subwoofer 2 x mono signal outputs max. 10 volts / 47 k ohms
subwoofer frequency response 15 - 150 Hz -1dB
subwoofer 2 x mono low pass variable 40 - 150 Hz / 24 dB
subwoofer total distortions 0.001 %
signal noise ratio subwoofer and satellites over 95 dB
power consumption with signal input max. 3 watts
power consumtion without signal max. 2.5 watts
Connection with following steps:
1. All units to be connected are switched off. Turn all knobs of F-1 to far right.
2. If the voltage printed at the back side (110 V or 230 V) is equivalent to your house voltage
connect the AC plug with your house AC or your amplifier “switched” AC out. When
connected to your amplifier the F-1 will be always switched on and off with your amplifier
which saves energy. On your house AC the steady power consumption is below 2.5 watts.
3. For all signal connections use RCA cables. INPUT connect as sketches A to G.
B is useful if the Subwoofer input signal is too low. C is requested if SAT OUT = Satellite
output signal is needed.
4. SAT OUT connect as sketches H or J.
R
L
R
Audio/Video Receiver
LFE-MONO OUT
Audio/Video Receiver
PRE OUT FRONT
C
A
Audio/Video Receiver
LFE-MONO OUT
Stereoamplifier
PRE OUT
L
R
L
R
Preamplifier
OUTPUT
D
E
B
F-1 INPUT
L
R
L
R
L
R
L
R
G
L
R
L
R
Stereoamplifier
TAPE REC
L
R
L
R
Taperecorder / CD
OUTPUT
F
J
L
R
L
R
SAT OUT
L
R
L
R
SAT OUT
H
-2-
F-1 INPUT
F-1 INPUT
F-1 INPUT
F-1 INPUT
F-1 INPUT
F-1 INPUT
Stereoamplifier
MAIN IN or AUX
Poweramplifier
INPUT
