4
PROGRAM
icons appear when the Receiver has been programmed to associate a
particular Sensor with that column. Messages from the Sensor associated with a
particular column control the ALARM and SIGNAL icons in that column. ALARM and
SIGNAL icons will never appear for an unprogrammed column.
SELECT
icons appear only in PROGRAM mode. The Select icon indicates which
Sensor number is being programmed.
The fifth row of icons is not specific to any Sensor and indicates the Receiver’s
mode:
MONITOR, OFF, PROGRAM
or
ERASE
. In the case of
OFF
and
ERASE
modes the remaining time in seconds until activation (receiver turns off or program-
ming is erased) is displayed graphically with a 5 second countdown timer as follows:
Turning the Receiver On and Off
If the Receiver is off, then pressing the MODE button once will turn the Receiver
on. The Receiver always comes on in the MONITOR mode. In MONITOR mode the
Receiver will receive messages from any programmed Sensor. Within one minute
the SIGNAL icons for any programmed Sensors will come on if the Sensors are in
communication range. Motion messages from programmed Sensors will turn on the
ALARM icon for 5 seconds, and simultaneously:
1.
Vibrate the motor three times.
2.
Flash the LED backlight three times.
3.
Beep the buzzer three times if it is turned on.
Pressing the MODE button while in MONITOR mode causes the OFF icon to appear
(see Figure 3)
and the countdown timer to start. If the MODE button is not pressed
for 5 seconds, the timer will turn the Receiver OFF. The MODE button is the ON/OFF
switch. All programming is saved when the Receiver is off.
