9
7. Assembly Instructions
- cont.
Installing Table
Fig 7.5
.
1. Use 4 M6 x 16 pan head screws to fasten both table support mounts
onto the front of the machine.
2. Place the support table with scale onto the table support mount.
3. Put a 6 mm flat washer on the table lock knob, and place the knob into
the tilt scale plate and mount and tighten by hand.
4. Place the table onto the table support, align the 4 screws which are pre-
assembled under the table with the holes of the table support.
5. Put the external lock washer and hex nut onto the screws and tighten.
6. Adjust the table and re-tighten the table lock knobs.
Warning: To avoid trapping the work or fingers between the
table and sanding surface, the table edge should be a maximum
of 3 mm from sanding surface.
7. Loosen the 4 M6 hex nuts under the table.
8. Using a suitable spacer, for example a 3 mm thick piece of card or 3 mm
diameter drill bit, hold the table against the spacer and tighten the 4 M6
hex nuts,
Fig 7.6
.
Squaring Table Assembly
Warning: To avoid injury from accidental starting, make sure the
machine is unplugged before aligning.
1. Using a combination square, check the angle of work table with the disc.
Note: The combination square must be true,
Fig 7.7
.
2. If the table is not at 90º to the disc, loosen table lock knob screw and
adjust the table.
3. Adjust work table square to the disc and re-tighten table lock knob.
4. Adjust the pointer to zero mark on the scale plate.
i
Kg
i
Kg
i
Kg
Fig 7.5
Fig 7.6
Fig 7.7
