22
10.4.
WG250/D
Plane Camber Jig
Use to sharpen camber plane blades up to 76 mm (3” wide).
The plane camber jig slides on the support arm of the wet stone sharpener.
A
Camber lock knob
B
Camber setting screw and lock
C
Fence
D
Blade lock knob
E
Rocker pad
Using the Plane Camber Jig to Sharpen a Camber
Mount the support arm in upper position.
Position the plane blade in the centre of the jig as shown in
Fig 10.4.1
. Use
the fence to ensure the blade is at 90º to the jig,
Fig 10.4.2
, then lock the
blade in place using the blade lock knobs.
Ensure the camber lock knobs are released to allow the camber plate to
move as shown in
Fig 10.4.3
.
To set the desired camber, position the camber setting screw as required and
secure in place with the lock as shown in
Fig 10.4.3
. The depth of camber
will increase when the screw is set in the lower positions.
Both camber setting screws and locks must be set equally to achieve a
symmetrical camber to the blade.
Position the blade at the required angle to the stone and pass across the
stone from left to right, holding down the left hand rocker pad as shown in
Fig 10.4.4
.
B
C
A
D
E
Fig 10.4.2
Fig 10.4.4
Fig 10.4.3
Camber
lock knob
Camber plate
Setting screw
Lock
Fig 10.4.1
Summary of Contents for WG200
Page 39: ...39 ...
