Operation mode >
SERVICE STG
Maintenance >
Functions >
Configure System
Learning System >
Parameter >
PARAMETER
Driving Cycle >
Time delay open >
Drive >
Entrance System >
Control unit >
Locking >
DRIVE
Motor 6
Two Motors 0
EmergOp Battery 3
Power Failure 1
Battery 0
Speisung 0
EmergOp. Battery
0 Close, not lock
1 Unlock and open
2 Close and lock
3 Open, if not locked
Operation mode >
SERVICE STG
Maintenance >
Functions >
Configure System
Learning System >
Parameter >
PARAMETER
Driving Cycle >
Time delay open >
Drive >
Entrance System >
Control unit >
Locking >
Determines Battery Operation
DRIVE
Motor 6
Two Motors 0
EmergOp Battery 3
Power Failure 1
Battery 0
Speisung 0
POWER FAILURE
0 Battery operation
1 Emergency operation
Battery Operation is only possible
with Lead Battery.
In case of low battery, upon a power
failure, Emergency operation is
immediately executed.
Operation mode >
SERVICE STG
Maintenance >
Functions >
Configure System
Learning System >
Parameter >
PARAMETER
Driving Cycle >
Time delay open >
Drive >
Entrance System >
Control unit >
Locking >
DRIVE
Motor 6
Two Motors 0
EmergOp Battery 3
Power Failure 1
Battery 0
Speisung 0
BATTERY
0 Without
1 Lead
Automatically identified if battery
connected prior to commissioning. If
battery is added after commissioning,
this parameter must be enabled
manually. Additionally, the battery
charge/monitor pcb, 9-51-00167,
must be installed in the door control.
Operation mode >
SERVICE STG
Maintenance >
Functions >
Configure System
Learning System >
Parameter >
PARAMETER
Driving Cycle >
Time delay open >
Drive >
Entrance System >
Control Panel >
Locking >
ENTRANCE SYSTEM
Door type 19
Measure A 0
Measure G 0
Door Leaf 0
Interlock 0
MEASURE A
0
Door Opening Width Measured in
mm. 650.....2000 Default setting.
Only compulsory for folding doors. In
sliding door configurations, value is
automatically set during calibration.
For 4500 and FlipFlow, value shouild
be set to “2000”
Operation mode >
SERVICE STG
Maintenance >
Functions >
Configure System
Learning System >
Parameter >
ENTRANCE SYSTEM
Door type 19
Measure A 0
Measure G 0
Door Leaf 0
Interlock 0
ENTRANCE SYSTEM
Door type 19
Measure A 0
Measure G 0
Door Leaf 0
Interlock 0
PARAMETER
Driving Cycle >
Time delay open >
Drive >
Entrance System >
Control Panel >
Locking >
ENTRANCE SYSTEM
Door type 19
Measure A 0
Measure G 0
Door Leaf 0
Interlock 0
MEASURE G
0
Door Opening Height Measured in
mm. Not used yet.
If “1 Emergency Operation” is
selected in “POWER FAILURE”
below, “ EmergOp.Battery” will
determine what function the door will
do upon a power failure. After
completion, the control will shut down.
If “Lead is selected in “Battery” below,
“0 Battery operation will maintain full
door operation until battery is
significantly discharged, then function
selected in “EmergOp. Battery” is
performed, followed by control
shutting down.
Note: “ Speisung 24VDC” not used in
North America.
