Record Speedgate slide, User Manual

Malfunctions

7

BAL_Speedgate_slide_EN_1V0_REC_102-905401041

19 / 26

7

Malfunctions

7.1

Fault Finding

During normal operation, the main control logic GC01 displays a collection of messages regarding the
normal status or the fault conditions. To read the messages displayed by the GC01 is the first check
to do in case of failure of the Speedgate Flap

Symptom

Check

Action

Panels do not drive

Check mains input voltage and
24 VDC supply on logic boards

Replace transformer

Fuses on all three logic boards

Replace as required

Increase back-off sensitivity

If F1 fuse has blown motor may
be permanently damaged

Check functionality of all the lo-
gic boards on each electrical
plate, especially MB01 drive
cards

Re Flash Firmware

Perform a re learn

Replace as required

Card reader inputs

Remove card reader connec-
tions and link across the inputs

Photocells, perform diagnostic
test using GC01 to check that all
the photocells are working

Replace faulty photocell(s) if re-
quired

Check brackets

Unit alarms

Battery back up

If fitted the cells may be in need
of replacement. If they are not fit-
ted the self-test function should
be disabled by changing the rel-
evant parameter Check looms.

Panels do not close after transit

Safety photocell

Replace if required

Panel(s) do not back off when
obstructed

Trimmer on MB01 drive card

Tune the obstacle sensitivity.

Replace MB01

Panel(s) pulses when in open or
close position

Trimmers on MB01 drive card

Tune the offsets.

Replace drive card if required

Panel(s) do not open and close
correctly

Trimmers on MB01 drive card

Launch the learning procedure.

Replace drive card if required

Encoders

Replace if required

Check encoder mounted cor-
rectly

Check looms

Check Mech setting

Panel(s) open and close very
fast.

Encoders, and encoder looms

Replace if required

Check encoder mounted cor-
rectly

Check looms

Check Mech Setting

Incorrect mechanism selected

Adjust on MB01 board