PAGE NO. 11
SPECIFICATIONS & DIAGRAMS
Technical Data for Remote Control & IR Receiver Unit
•
Input: 110VAC±10% (60Hz)
•
Output current to motor: ≤1A
•
Code error rate: ≤1/1000000
•
Remote control distance: ≤ 20m (65.6 ft)
•
Maximum number of remotes per IR receiver: 5 remotes
•
Control signal: IR 38Khz
•
Minimum and Maximum effective button press time: >0.3 sec to
±120 sec
Always call a qualified engineer for maintenance to avoid possible dan-
ger associated with opening screen enclosures. Always unplug the
screen before attempting any kind of service.
If your screen is not working check the following before calling for ser-
vice:
•
Check that the screen is getting power (test outlet with another de-
vice, I.e. Table lamp)
•
Check that the fuse is not broken (fuse is located inside the wall
switch).
•
Check that the power cable has not been pulled out of the screen
housing or out from the wall switch box.
If the remote control is not working properly try operating the remote
closer to the screen and out of direct sunlight. Also, try replacing the
remote battery.
OPERATING TIPS
•
Do not over use the screen motor as this could reduce the overall
life of the screen (I.e. Do not put screen up and down unless you are
planning to use the screen.)
•
Do not pull on the power cable.
•
Ensure the power cord is securely plugged into a grounded outlet.
•
Unplug the screen when it will not be used for long periods of time.
•
Make use of a surge protector to help protect your screen from un-
wanted electrical damage.
TROUBLESHOOTING & PROPER OPERATION
