1.
Near appliances or areas where normal combustion regularly occurs (kitchens, near furnaces, hot water heaters). Use
specialised smoke alarm with unwanted alarm control for these areas.
2.
In areas with high humidity, like bathrooms or areas near dishwashers or washing machines. Install at least 10 feet
away from these areas.
3.
Near air returns or heating and cooling supply vents. Install at least 3 feet away from these areas. The air could blow
smoke away from the detector, interrupting its alarm.
4.
In rooms where temperatures may fall below 4°C or rise above 38°C.
5.
In external dusty, dirty, or insect-infested areas where loose particles interfere with smoke alarm operation.
WARNING:
Incorrect orientation will result in a decrease in operational effecitiveness.
How To Install This Smoke Alarm
DANGER: ELECTRICAL SHOCK HAZARD.
Turn off power at the main fuse box or circuit breaker by removing the fuse or switching the circuit breaker to the OFF
position.
WARNING:
This smoke alarm is mains powered and requires wiring by a qualified electrician in accordance with the
current IEE Regulations for Electrical Installations (BS7671).
The circuit used to power the smoke alarm must be a dedicated permanent supply that cannot be switched off accidentally
by the normal user. Before installing, ensure the electrical supply is isolated.
1.
From back of smoke alarm, remove the mounting plate by turning it counterclockwise. (To later engage tamper-resist
feature, twist out and set aside one of the pins molded into plate. Both pins are exactly the same).
2.
Gently pull household wires through center hole of plate.
3.
Secure plate to ceiling or wall with mounting screws.
4.
With a small wire connector, connect the brown wire from connector plug to brown household wire.
5.
Connect blue wire from connector plug to blue houeshold wire.
6.
If interconnection is desired, connect yellow wire from connector to interconnect wire between smoke alarms.
See Section: Interconnecting Smoke Alarms
NOTE:
If this will be used as a single-station smoke alarm, cover yellow wire with electrical tape and tuck it into junction
box.
7.
Lift open battery pocket door.
8.
Connect new 9V battery to battery connector inside battery pocket. Be sure battery is securely connected. Smoke
alarm may beep briefly when battery is installed.
9.
Close battery pocket door, snapping it into place.
10.
Attach connector plug to pins on back of smoke alarm. Plug will only fit one way and will snap into place.
11.
Gently tug connector to be sure it is attached securely.
Mounting slots
Mounting bracket
Screw
9V Battery
