SENSOR (FLIP/MIRROR SCAN DIRECTION)
The Flip/Mirror Scan Direction feature rotates the image 180°, both on the monitor and in the recorded R3D file.
Normally, the sensor scans the image from the top to the bottom. When the Flip/Mirror Scan Direction feature is
enabled, the sensor scan direction reverses, and the sensor scans the image from the bottom to the top.
The Flip/Mirror Scan Direction feature is intended for multi-camera arrays when all sensors are synchronized, and at
least one (1) camera is mounted upside-down. Using this feature is helpful for matching the line scan direction for the
cameras in the array.
To enable the Flip/Mirror Scan Direction feature, follow the instructions below:
1. Go to
Menu
>
Settings
>
Project
>
Sensor
.
2. Select the
Flip/Mirror Scan Direction
check box.
The camera rotates the image 180° on the monitor and in the recorded R3D file.
Figure: Flip/Mirror Scan Direction
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
9 5 5 - 0 1 3 3 _V 6 .3 , R EV - H
|
1 0 4
SCARLET-W OPERATION GUIDE
