LENSES
This section describes lenses and lens operations for the camera system.
WARNING:
All lenses are hot swappable.
All lenses are hot swappable. However, lens mounts are NOT HOT SWAPPABLE, meaning you cannot remove or
install lens mounts while the camera is turned on. Before installing or removing lens mounts, you MUST turn off the
camera. Failure to do so may result in damage to the lens mounts or camera that is not covered under warranty.
LENS WEIGHT AND LENS SUPPORT
Use a lens support system when mounting heavy or long lenses to your camera.
When mounting a heavy or long lens, ensure that the full weight of the lens is never directly on the camera or lens
mount. Mount the lens to the support system first, and then carefully mount the lens to the camera.
WARNING:
Failure to use lens supports appropriate for the lens and camera setup may lead to damage of the camera
and lens mount. Any damage caused by not using a lens support system will not be covered under warranty.
POSITIVE LOCK (PL) LENSES
This section describes the appropriate method for attaching and detaching PL lenses. For more information, refer to
the original manufacturer’s instructions. This section also lists lenses supported by the camera PL mounts.
WARNING:
ALWAYS protect your equipment, when it is not in use, by replacing lens caps and mount caps.
ATTACH PL LENSES
1. Rotate the locking ring counter-clockwise to release the camera mount cap.
2. Remove the rear lens cap and the camera mount cap.
3. Align the key and contact pads (if present) on the PL lens with the key and connector pins on the camera PL
mount.
4. Insert the lens into the camera PL mount.
5. Rotate the locking ring clockwise to secure the lens in place.
DETACH PL LENSES
1. Rotate the locking ring counter-clockwise to release the PL lens.
2. Remove the PL lens from the camera PL mount.
3. Replace the rear lens cap and camera mount cap when the lens is not in use.
CAMERA PL MOUNT SUPPORTED LENSES
The DSMC Mg PL Mount 2.0, DSMC TI PL Mount, and the RED MOTION MOUNT Ti PL are compatible with most
standard PL mount cinema lenses and devices. For information about the compatibility of the RED MOTION MOUNT
Ti PL, see the
.
WARNING:
Using a non-standard PL mount lens or device with a camera PL mount may damage the camera and lens
mount. Any damage caused by not using a standard PL mount lens or device will not be covered under warranty.
FUJINON T2.9 CABRIO PREMIER PL LENSES
NOTE:
The VTR switch on the lens is mapped to Record: Toggle by default. The VTR switch can be mapped to
another key.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
9 5 5 - 0 1 3 3 _V 6 .3 , R EV - H
|
2 3 5
SCARLET-W OPERATION GUIDE
