AUTO BOOT ON POWER
The DSMC2 Jetpack Expander, DSMC2 Jetpack-SDI Expander, DSMC2 REDVOLT Expander, and the DSMC2 V-Lock
I/O Expander feature a selector switch that enables the camera to automatically boot when power is provided via the
DC IN connector on the expander. The Auto Boot on Power switch (identified by a white star) is located on top of the
expander.
When Auto Boot on Power is enabled, the camera disables all power sources that are not the DC IN connector on the
expander, including batteries and the DC IN connectors on any modules.
Figure: Auto Boot on Power Switch
ENABLE AUTO BOOT ON POWER
1. Toggle the
Auto Boot on Power
switch to
On
(identified by a white star).
2. Connect a power source to the
DC IN
connector.
The camera turns on automatically.
3. Use one of the following methods to turn off the camera:
Go to
Menu
>
Power
and select
Shutdown
.
Press and hold
PWR/REC
until the
Shutting Down...
notification shows on the display.
NOTE:
Simply disconnecting the power source may result in data loss.
DISABLE AUTO BOOT ON POWER
1. Toggle the
Auto Boot on Power
switch to
Off
(identified by a black star).
The camera will not turn on automatically.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
9 5 5 - 0 1 3 3 _V 6 .3 , R EV - H
|
4 0
SCARLET-W OPERATION GUIDE
