REDCODE BURST
NOTE:
This mode is not available in Stills mode.
NOTE:
Audio is not recorded in REDCODE Burst mode.
In REDCODE Burst mode, the camera can record at a lower compression (REDCODE) for the specified amount of
frames. When REDCODE Burst mode is enabled and recording starts, the camera captures a “burst” of frames at the
lower REDCODE, and then continues to record at the next available REDCODE. To add more bursts to clips during
recording, press any key mapped to “Record: Mark Frame”.
To use REDCODE Burst mode, follow the instructions below:
1. Go to
Menu
>
Settings
>
Recording
>
Mode
.
2. Select
REDCODE Burst
from the
Mode
drop-down menu.
3. Use the
Limit Recording to
fields to set the recording to end at a predefined frame limit (optional).
4. Select a
Pre Count
and
Post Count
. For more information, go to
"Pre Count and Post Count" below
.
5. Close the menu.
6. Start recording.
PRE COUNT AND POST COUNT
When Frame Trigger or Burst mode is enabled, select the number of frames for the Pre Count and Post Count:
Pre Count
: The camera captures the frame cache from the time preceding the marker.
Post Count
: The camera captures the remaining frame cache after the marker.
The maximum frame counts are listed in the Available column, and are based on format and REDCODE.
MULTI-SHOT
NOTE:
The camera does not sync timecode in Multi-Shot mode.
NOTE:
This mode is available in Motion mode, but is only recommended in Stills mode.
NOTE:
Audio is not recorded in Multi-Shot mode.
Multi-Shot mode removes restrictions on Recording Frame Rate and REDCODE, allowing you to shoot at a high
resolution, high frame rate, and low compression. These restrictions are removed because the camera records first to
the camera’s memory, and then offloads (while recording) to SSD after the camera’s buffer fills up. Since the camera
records only as fast as the buffer can transfer data, frames are dropped from the clip.
Multi-Shot mode has two sub-modes:
Basic Multi-Shot mode
Advanced Multi-Shot mode
BASIC MULTI-SHOT MODE
In Basic Multi-Shot mode, you can record a one-frame clip by pressing a Record key, or you can continuously record
frames by holding a Record key. This mode is the easiest way to shoot stills, but there is some latency (about 700
milliseconds) when you press Record.
This mode only involves the Record key on the media bay.
Pressing the PWR/REC key on the camera initiates Advanced Multi-Shot mode.
To use Basic Multi-Shot mode, perform one of the following:
Press a
Record
key to record a one-frame clip.
Press and hold a
Record
key to start a new clip and continuously add frames to that clip. Release the
Record
key
to stop adding frames and end the clip.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
9 5 5 - 0 1 3 3 _V 6 .3 , R EV - H
|
1 0 7
SCARLET-W OPERATION GUIDE
