POWER PORTS
DC IN (POWER INPUT)
The following expanders feature a DC IN connector:
DSMC2 Base Expander
DSMC2 V-Lock I/O Expander
DSMC2 Jetpack Expander
DSMC2 Jetpack-SDI Expander
DSMC2 REDVOLT Expander
The 6-pin 1B LEMO connector accepts DC input power from 11.5 V DC to 17 V DC. A built-in power conditioner
protects against reverse- polarity connections, electrostatic discharge (ESD), undervoltage, overvoltage, and
overcurrent.
WARNING:
Both pairs of +VBATT and GROUND pins must be wired. Using a third-party power cable that wires only
one (1) pair of +VBATT and GROUND pins may damage the power supply or the camera. Damage to the power
supply or other components of the camera system caused by using an inappropriate power cable is not covered
under warranty.
Figure: Front Face of the DC In Power Input Connector (Looking at the Camera)
6-PIN 1B DC INPUT CONNECTOR
PIN
SIGNAL
DESCRIPTION
1
+VBATT
Power input, +11.5 to +17 V DC
2
+VBATT
Power input, +11.5 to +17 V DC
3
SCL-BATT
Serial battery bus clock
4
GROUND
Power return (camera ground)
5
GROUND
Power return (camera ground)
6
SDA-BATT
Serial battery bus data
NOTE:
Mating connector is FGJ.1B.306.CWLD72Z.
C O PYR I G HT © 2 0 1 6 R ED.C O M , I NC
9 5 5 - 0 1 3 3 _V 6 .3 , R EV - H
|
2 2 5
SCARLET-W OPERATION GUIDE
