Revised 2017-08-31
Advanced Tab
Drawing No. LP0997-C
GWLNX
Sixnet
®
Series SN/RAM
®
6000 & RAM 9000 Software Manual
- 249 -
Click on the
Add
button to define IP Destination Settings.
Enter Address 1 (Required):
This is a Client Primary IP Address that GWLNX uses to connect to the Host
Server.
Enter Port 1 (Required):
This is a Client Primary Port Address that GWLNX uses to connect to the Host
Server Port.
Connect Timeout 1 (Required):
Specify the time in seconds to attempt a connection to this TCP Destination,
before declaring it unreachable. After the specified time, the next destination will be attempted. Valid range is 2
-250 seconds. The recommended setting for this field is 10 seconds. A value less than 10 seconds is not
recommended for a wireless environment
Enter Address 2:
This is a Client First Alternative IP Address that GWLNX uses to connect to the Host Server.
Enter Port 2:
This is a Client First Alternative Port Address that GWLNX uses to connect to the Host Server
Port.
Connect Timeout 2:
Specify the time in seconds to attempt a connection to this TCP Destination, before
declaring it unreachable. After the specified time, the next destination will be attempted. Valid range is 2 - 250
seconds. The recommended setting for this field is 10 seconds. A value less than 10 seconds is not
recommended for a wireless environment.
Enter Address 3:
This is a Client Second Alternative IP Address that GWLNX uses to connect to the Host
Server.
Enter Port 3:
This is a Client Second Alternative Port Address that GWLNX uses to connect to the Host Server
Port.
Connect Timeout 3:
Specify the time in seconds to attempt a connection to this TCP Destination, before
declaring it unreachable. After the specified time, the next destination will be attempted. Valid range is 2 - 250
seconds. The recommended setting for this field is 10 seconds. A value less than 10 seconds is not
recommended for a wireless environment.
Header Type:
This is a Header Length used in TCPIP packet that contains the Message Length being Send or
Receive. The recommended setting for this field is Default.