Revised 2017-08-31
Events
Drawing No. LP0997-C
Sixnet
®
Series SN/RAM 6000 & RAM
®
9000 Software Manual
- 255 -
3.8
Events
Events are used to apply a series of logic checks to a register(s) that allows the user to program an action based
on the content of a specific register. Properly configured events can identify when a tank level is too high or if the
RSSI signal strength has deviated outside an expected range, then react by writing to a known output and/or status
register.
Multiple
events
can
be
used
to
create
more
advanced
logic
or
to
create
multiple
stages
of
severity
for
alarms.
See Appendix B
for a list of system status variables that are already established in the IODB. For example, events
can be configured to watch these values and trigger actions based on when a reboot occurs (system uptime < 2
minutes), when a cellular link is down (wwan0 connected = 0), or when data traffic measured over a month
exceeds a user’s threshold.
Note:
Not all models have the same Events capabilities. Please call Red Lion Technical Support or your local
representative for more details.
Enable Events:
Select
YES
to enable the Events Control service. If
NO
is selected, all events will be disabled.
Update Status:
Click the
Update Status
button to get a current event status.