26
USER MANUAL
▪
Red Rooster Lifting Limited
▪
Nauta House, The Meadows, Oldmeldrum, Aberdeenshire, AB51 0EZ
▪
Tel: +44 (0) 1651 872101
▪
M01-AH35-CH REV3
SERVICE DATA
Maintenance chart
TMH-10T
NO.
DESCRIPTION
CHECK POINTS
STD DIMENSIONS & MAX FOR REPLACEMENT
55
Vane
STD L = 136mm
MIN L = 135mm
STD W = 23mm
MIN W = 21mm
STD T = 4mm
MIN T = 3.5mm
Replace if any of the width, length and thickness is less than
the stated minimums.
152
Brake Disc
STD T = 8mm MIN T = 7.3mm
Below minimum for replacement.
STD W
= 2.6mm MAX W
= 2.8mm
Above maximum for replacement
213
Cage
Replace when there is a large or uneven play in the pin hole.
201
202
204
205
206
208
209
210
212
First pinion
First star gear
First ring gear
Second pinion
Second star gear
Second ring gear
Third pinion
Third star gear
Third ring gear
Replace if there is a step on the surface of the gear teeth.
203
207
211
First pin
Second pin
Third pin
step
Replace if there is a step on the surface of the pin.
If the pin is replaced, replace the needle bearing and star gear
at the same time.
128
Chain end pin
Measure the contact area of the pin and the chain.
Replace if the wear exceeds 1mm.
step
T
W
L
T
W
W
ear
