Red Sea MAX
®
NANO
14
8 Installation of LED Modules
The LED unit for the MAX
®
NANO is attached to the mounting arm by a
ball joint, allowing tilt and swivel. The mounting arm is attached to the
aquarium by the hole provided for it in the top of the Pump Switch-box
The complete LED assembly can be rotated from side to side for ease
of aquascaping and maintenance of the rear sump, specifically when
removing the skimmer.
1.
Thread the LED cable
through the ball-seat as
shown in the diagram until
the ball-seat is about 10cm
(4") from the LED unit.
2.
Using a cross head
screwdriver, partially
attach the ball-seat to the
mounting arm with the 2
screws provided, one full
rotation of the screwdriver
should be enough to hold
the ball-seat in position.
3.
Carefully move the LED unit
into position so that ball
sits correctly in the ball-
seat while threading the
cable through the recess
provided for it.
4.
Press the ball-seat to the
mounting arm, trapping
the ball in between the
parts and tighten the 2
screws until the ball is held
firmly.
Tip – place the LED unit
on a work surface with
the ball protruding over the edge, hold the mounting arm with
one hand at the connector end and press on the ball-seat from
underneath so that you have easy access to the screws from above.
5.
Thread the cable through
the hole in the bend of the
mounting arm and push
the cable-hole plug into
position.
6.
To attach the LED mounting
arm to the switchbox hold
it so that the pin at the
bottom of the arm is over
the hole in the switchbox
and the LED unit is facing
sideways as shown in
the diagram. Place the
cable over the back of the
aquarium.
Home
Installation and Operation Manual
