Red Sea ReefLED
™
10
appear on your screen. This may take a few seconds. If no devices
appear on the list, check that the ReefLED is in AP mode and/or refresh
the page. If you have installed multiple ReefLEDs and you have already
activated the AP mode on all of them, you will see a list of all of the
ReefLEDs. Choose any one of them as the first unit and continue as
instructed by the app.
Connecting to the Home Network
ReefBeat will now display a list of Wi-Fi networks and signal strengths that
are available to the ReefLED from its current location. Note: if the ReefLED
is not in its position above the aquarium, your preferred network may not
be accessible when the ReefLED is repositioned.
Select your preferred network and wait a few moments while the ReefLED
connects to it. The indicator LED will now be a solid red. Follow the
instructions on the app for initial settings.
Connecting without a Home Network (Direct Mode)
ReefBeat will now display a list of Wi-Fi networks and signal strengths
that are available to the ReefLED in its current location. Select the “Direct
Mode” option at the top of the screen to skip the network connection (See
Connectivity Modes).
The indicator LED will continue to blink as the ReefLED WI-Fi remains in AP
mode. Follow the instructions on the app for initial settings.
Connection and initial setup
Installing ReefBeat
Download ReefBeat from the app Store or Google Play as appropriate for
your SMD. (In countries without access to Google Play an APK file and
installation instructions can be downloaded from Red Sea’s website.)
After installing ReefBeat, you will be guided through the set-up of your
ReefBeat user account and aquariums, and then you can start adding
your Red Sea connected devices. All of your user account details can be
edited only when your SMD is connected to the internet.
For full functionality Red Sea’s connected devices should be connected to
the internet and your aquariums should be set to “Online”. In the event
that you do not have an available Wi-Fi network at your Aquarium, set
it as “Offline”. You can change this setting later when WI-Fi becomes
available.
Make sure that you select the correct world time zone for where your
aquarium is located. The default is the same time zone as your SMD
which might be set for a different location.
If you’ve set up more than one aquarium, select the aquarium from the
dropdown menu at the top of the screen before proceeding.
Adding your first ReefLED to ReefBeat
Set your ReefLED to AP mode by pressing the settings button for 5
seconds (until double blink). The indicator LED should be blinking.
Tap the Add Device button ( ) from the Device Manager page, select
the ReefLED icon and follow the instructions on the app. If you are asked
to enter the device serial number, it can be found on the back of the
ReefLED unit. If not, the unique serial number of the ReefLED should
Summary of Contents for ReefLED 50
Page 1: ...ENG User Manual...