RED SHIELD SMART HALO, User Manual

12

Keys

Description

Note

• Toggle 1, 2, 3, 4, 5, 6, 7, 8 to turn each zone ON or OFF
• If no number appears, the zone is turned OFF
• If all zones are enabled, the Smart Halo Panel will display the
image as:

Press             then               
to set the ARM mode

Confirm the setting and return the Smart Halo Panel to STANDBY 
by pressing

Press                to complete 
the setting

B. Disarming the system

• On the Smart Halo Panel: Enter your 4-digit PIN followed by               to disarm the system.
• On the Key Fob Remote Control: Press            to disarm the system

C. Zone settings

Programming each zone in ARM mode:

•  There  are  30  seconds  of  entry  delay  time  with  a  visual  countdown  for 
disarming.
• Once an intrusion has occurred (zone triggered under ARM status), the 
alarm siren will sound for 1 minute and the Smart Halo Panel flashes RED 
every 1.5 seconds with the triggered zone indicated, until the system is 
disarmed.
*To disarm the system, enter the 4-Digit PIN or press          on the remote 
control.

• The Smart Halo Panel will display the below image:

• One  beep indicates that the system is triggered.

Entry delay 30 seconds

Description

Note

Under the “ARM” Mode

System trigger

After the initial triggering, the alarm will immediately sound, without delay, if 
any other sensors are triggered.

Return to ARM mode after 
the initial triggering

D. Triggers in ARM mode

Example: Zone 1 trigger

3.3 Introduction of Key Fob Remote Control

A. Introduction

The Red Shield SMART HALO Home Protection System Remote Control allows you to operate the systems Smart
Panel remotely, from inside or outside the property. Using the control the system can be armed or disarmed and the
siren can be activated instantly if required (using the Panic function).

B. Operation
i. Powering up the Key Fob Remote Control

The Remote Control includes a 12V alkaline battery. To activate, unscrew and remove the back of the Remote Control, 
and carefully remove the clear plastic insulation tab from the battery. If the battery is dislodged, replace it noting the 
correct polarity as shown inside the battery compartment. Replace the battery cover.