16
4.2 Installing the Sensors
First, determine the location of the sensors.
*Note: The sensors should be placed:
- where they are not easily accessible.
- in the most vulnerable rooms or near key entry points.
- away from extreme temperature sources (radiators, ovens, stoves etc.) and large metal objects that could interfere
with the wireless performance.
- where better RF performance can be achieved (if necessary).
Once you have selected a location for the sensors, the system can be powered up.
4.2.1 Installing the Door/Window Sensor
The Door/Window Sensor consists of two parts, a transmitter and a magnet. Once this sensor is installed, and the two
parts are fastened onto the door or window, the sensor will trigger and transmit a message to the Smart Halo Panel
when the door or window is opened. One Door/Window Sensor is pre-programmed in Zone 1 and the other one is set
in Zone 2; however, these settings can be adjusted according to your requirements.
A. Powering up the the Door/Window Sensor
• Remove the battery cover; insert new batteries noting the polarity as shown in the
diagram below and replace the cover. (Requires 2 x AAA batteries)
• Low battery indication: If the batteries need to be replaced, the RED LED on the
transmitter will flash slowly.
3.5 Transmitting an emergency (Panic) alarm
3.5.1 Using the Panic alarm
Pressing & buttons together on the Keypad or Key Fob Remote Control will immediately transmit an alarm
signal to the Smart Halo Panel, activating the siren, and transmitting an alarm signal to any optional response devices
(Auto Dialer & Outdoor Bell Box), to request emergency assistance
To disarm the Panic alarm
On the Smart Halo Panel: Enter your 4-digit PIN followed by to exit from the Panic alarm.
On the Key Fob Remote Control: Press to exit from the Panic alarm.
3.5.2 Using the Panic alarm without activating the siren
If you are forced to disarm the system, enter the Duress Password to stop the siren from sounding. The Smart Halo
Panel will then silently transmit an alarm signal to the optional response devices (Auto Dialer & Outdoor Bell Box) to
request emergency assistance.
Duress Password:
Enter the default 4-digit PIN + (+ + ) +
OR
Enter your personalised 4-digit PIN + +
SECTION 4 – INSTALLING THE SENSORS
4.1 Introduction to the Sensors
This package includes 3 wireless sensors which have a pre-programmed default setting that begins working
immediately once the battery is activated. It is advisable to install the main package first and then personalise the
settings once the system is functioning properly. This section should help you to change the system settings in order
to create a more personal home environment.
