19
7-TYPE OF INSTALLATION
INSTALLATION WITH THE FLAT ROOF KIT - SOLUTION FOR SPECIAL ROOFS
Telescopic U section to adjust the slope of the collector. The length of U sections can be
adjusted telescopically if the collector slope must be adjusted to be greater or smaller.
Two stainless steel screws (M8x50) and self-locking nuts are used to secure the device.
The telescopic U sections are fastened to the base
rails with M8x50 screws and self-locking nuts.
DIMENSIONS OF THE FLAT ROOF KIT
Intervals A
Approx. 800 – 1070 mm
Depth B
1650 mm
Telescopic height C
Extendable to an inclination of approx. 60°
Calculation of the distance between the rows of collectors to prevent reciprocal shading (E.g.: Angle of elevation of the sun 17° at 21.12
– Germany)
Collector inclination (a)
min 34°
45°
60°
Distance (b)
6.05
6.85
7.55
Weight relative to wind load (kg/m
2
collector surface) in accordance with DIN 1055-4 (check correspondence with Ministerial Decrees of
16 January 1996 and 14 January 2008).
Height of construction
Without space from floor
With space from floor >30 cm
0 – 8 m
80 kg/m
2
*
60 kg/m
2
*
8 – 20 m
120 kg/m
2
*
100 kg/m
2
*
Technical Dept. - All rights reserved - Reproduction is prohibited
Summary of Contents for HIGH PERFORMANCE SOLAR COLLECTOR
Page 35: ......
