COPYRIGHT © 2015 RED.COM, INC
RED ROCKET INSTALLATION INSTRUCTIONS
955-0035, REV-D
|
20
4. Respond to the prompt to confirm which boards (cards) to install:
‒
To upgrade one RED ROCKET board: Type
Y
and press
Enter
.
‒
To upgrade all RED ROCKET boards: Type
A
and press
Enter
.
‒
To cancel the upgrade: Press any other key and press
Enter
.
The upgrade process begins, and may take several minutes.
After the firmware is upgraded, you will be prompted to fully shut down the computer and power back up
again.
5. Close the terminal/command window.
6. Shut down the computer. DO NOT simply restart the computer.
7. If the RED ROCKET is in a Thunderbolt chassis, disconnect power from the Thunderbolt chassis after the
computer fully shuts down.
8. Wait a minimum of 60 seconds.
9. If the RED ROCKET is in a Thunderbolt chassis, power up the Thunderbolt chassis.
10. Start the computer.
11. To verify that the system recognizes the RED ROCKET, go to
“Validate RED ROCKET Installation” on page
.
