© Red20RC 2015
13
Now we need to fit the legs to the frame. This can be a fiddly task so don’t even
start it if you are stressed! Go and get a cup of coffee and take a break – we can
wait…
The leg assembly should fit into the slots in the arm. All legs and slots are
identical so it doesn’t matter which goes where.
With the tabs located in the slots, pass the M3x16mm steel screws through the
holes in the arm and then through the holes in the leg mounting plate.
Secure carefully with the M3 washers and Nyloc nuts provided. Space is tight in
there so it is recommended to use some fine needle-nosed pliers (the bent ones
would be even better) to hold the nut whilst you tighten the bolt from the other
side.
Summary of Contents for R450 Spider
Page 1: ...R450 Spider Quadcopter...
Page 3: ...Red20RC 2015 3...
