32
3
USER GUIDE
Ignition selects Ignition Trigger, Auto is controlled by The Manager30, and 12 V
or 24 V lock the unit to a 12 V or 24 V system. ON means the unit can trigger DC
charging whenever there is a voltage between 9 to 32 V on the DC Input wire.
The default value is ‘Auto’.
Confirm Setting
Change Setting
Cancel Setting
Change Setting
This screen is used by REDARC to identify problems with a The Manager30 setup and
does not need to be accessed unless requested by REDARC Technicians.
Start Process/ More Info
Set DC Input Trigger Screen
Advanced Settings Screen
MaxCharge Current Screen
This screen gives the option of restoring the Factory Settings for The Manager30. A list of
the factory settings can be found in section 3.8.
Restore Settings/ Confirm
Advanced Settings Screen
N/A
About Screen
The About Screen allows you to access information about the build of The Manager30 and
the company. You may be asked to access this menu should you ever call up for technical
support with The Manager30.
About your Manager30
Factory Settings Screen
N/A
MaxCharge Current Screen
3.6
Fault Screens
If The Manager30 detects a problem with the charging system that does not prevent it
from charging the battery, it will alert you via a Warning screen and an alarm buzzer, and
continue charging. The screen will give a brief description of the problem and allow you to
select either ‘Clear’ or ‘Ignore’. Both options will clear the warning screen. After selecting
‘Clear’, however, The Manager30 will immediately check to see if the fault condition still
exists. If it does, it will display the warning screen again. Selecting ‘Ignore’ will prevent The
Manager30 from detecting the same fault for up to one minute.
NOTE:
If “Ignore” is selected but the fault is not removed, when the warning re-appears
after one minute, it will not be accompanied by the alarm buzzer.
The troubleshooting section (3.7) of this manual contains a description of faults detected.
Clear Warning
N/A
Ignore Warning
N/A