background image

1

Monocrystalline Folding Solar Panels Instruction Manual – Version1

MONOCRYSTALLINE FOLDING SOLAR PANELS

REDARC folding solar panels are designed to provide a solar charging solution for your auxiliary 
battery. They feature the folding panel with 50 Amp Anderson Plug connection and a strong nylon 
carry bag.

WARNING & SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

 — This manual contains 

IMPORTANT SAFETY INSTRUCTIONS for REDARC 
Monocrystalline Solar Panels.
DO NOT operate Monocrystalline Solar Panels UNLESS YOU 
HAVE READ AND UNDERSTOOD THIS MANUAL and the Panel 
is installed as per these installation instructions. REDARC 
recommends that the Panel be installed by a suitably  
qualified person.

WARNING

RISK OF EXPLOSIVE GASES:

Working in vicinity of a Lead-Acid battery is dangerous. 
Batteries generate explosive gases during normal operation. 
For this reason, it is of utmost importance that you follow the 
instructions when installing and using the Solar Panel.

WARNING: 

Check the manufacturers data for your battery 

and ensure that the ‘Absorption’ voltage of the regulator you 
select does not exceed the manufacturers recommended 
maximum charging voltage. If the ‘Absorption’ voltage for your 
battery type is too high, please select another charging profile 
or regulator (regulator not included).

CAUTION

1.  This appliance is not intended for use by persons 

(including children) with reduced physical, sensory or 
mental capabilities, or lack of experience and knowledge, 
unless they are supervised or have been instructed on 
how to use the appliance by a person responsible for their 
safety. Children should be supervised to ensure that they 
do not play with the appliance.

2.  Do NOT connect the Solar Panel directly to a Battery. A 

Solar Regulator must be used between the Solar Panel 
and the Battery.

3.  Only use the Solar Panel for charging Lead Acid, Gel, 

Calcium content, AGM or Lithium Iron Phosphate 12V 
batteries using a Solar Regulator suitable for the  
Battery’s chemistry.

Check the manufacturer’s data for your battery and ensure 
that the ‘Maximum’ voltage of the profile you select does not 
exceed the manufacturer’s recommended maximum charging 
voltage. If the ‘Maximum’ voltage is too high for your battery 
type, please select another charging profile.

4.  The Battery should be mounted in a well ventilated area, 

as far as possible from any ignition sources. NEVER 
smoke or allow a spark or flame in the vicinity of battery 
or engine. This may cause the battery to explode.

5.  An unconnected panel exposed to light may generate 

voltages greater than 20V on their leads. Completely cover 
all panels with an opaque material during installation, and 
when connecting or disconnecting conductors to reduce 
the chance of an electrical spark.

6.  The Solar Panel will achieve best results when proper 

battery maintenance is regularly performed. This includes 
but is not limited to checking water and specific gravity 
levels of the battery.

7.  Do not use mirrors or other devices to artificially 

concentrate sunlight on the panel.

8.  All panels used in series, parallel, or series-parallel should 

be positioned to receive identical amounts of light to 
reduce risk of panel damage.

9.  Partially shaded or partially obscured solar panels will have 

reduced output, and can potentially damage the solar panel.

PERSONAL SAFETY PRECAUTIONS

10. To assist with the safe operation and use of the Solar 

Panel when connected (via a Regulator) to the battery:

a) Wear complete eye protection and clothing protection. 

Avoid touching eyes while working near a battery.

b) If battery acid contacts your skin or clothing, remove 

the affected clothing and wash the affected area of 
your skin immediately with soap and water. If battery 
acid enters your eye, immediately flood the eye with 
running cold water for at least 10 minutes and seek 
medical assistance immediately.

WARNING

Check the manufacturers data for your battery and ensure 
that the ‘Absorption’ voltage of the regulator you select does 
not exceed the manufacturers recommended maximum 
charging voltage. If the ‘Absorption’ voltage for your battery 
type is too high, please select another charging profile or 
regulator (regulator not included).

Summary of Contents for SPFP1120













Reviews: