SmokeSight SS10MANN V0.6
Page 4
5
Wired Interlinked Smoke Alarms
Interlinking smoke alarms ensures that if one alarm
senses smoke, all of the connected alarms will operate
(alarm). While all interlinked alarms will sound, only the
alarm(s) that sensed smoke will fast flash their red LED. A
signal is applied to the interlink wire (referenced to
neutral) to connect to the other interlinked alarms.
Alternate smoke alarms (Part# SS10MAMA or SS10LNAN)
may be purchased separately if wired connection is not
possible. Refer to ‘Installation’ for the interlink
connection arrangement.
EQUIPMENT INSTALLATION HAZARD
• All interlinked smoke alarms must be supplied from the
same circuit. A common Neutral must be used
• DO NOT connect the Interlink wire to Active or Neutral.
• Maximum of 40 interlinked smoke alarms.
• Only SmokeSight alarms can be interlinked.
Failure to follow these instructions may result in
equipment damage or injury
6
Installation
1.
If tamper prevention is required, prevents alarm removal without the use of a tool, remove the Tamper Clip
from the mounting base by twisting it back and forth until it breaks loose.
2.
Strip the Active, Neutral and Interlink (if used) wires. Use a minimum of 1mm
2
250VAC insulated wire for all
wiring, including the interlink wiring.
3.
Connect the wires to the correct terminals on the base and ensure that the terminal screws are tight.
4.
Slide the terminal cover closed to avoid contact with the live terminals.
Mains Supply
220-240VAC
Active (A) – Red
Neutral (N) – Black
InterLink (IL) - Optional
5.
Screw the mounting base onto the ceiling or wall using appropriate fasteners. Screw diameter 8gauge/4mm.
6.
Apply smoke alarm power by installing 2xAA batteries into the into the bottom battery bay of the smoke alarm.
7.
Engage and slide the smoke alarm along the mounting base until it is fully home and it ‘clicks’. The smoke alarm
will only travel home and click if the smoke alarm batteries are installed. Note: Do not attempt to slide the alarm
onto the mounting base unless the smoke alarm batteries are installed as damage may result.
