DS3100
- 11 -
Use of different spread materials
Different spread materials require different settings. The
RINK Disk Spreader DS3100
can be
adjusted to any spread materials in the following manner.
- Rotation of the throwing vanes (see disk setting with uneven spread pattern - fig. 4)
- Regulation of the conveyor belt speed by regulator (1) (see p. 9 - fig.1)
- Regulation of the spreader disk speed by regulator (2) (see p. 9 - fig.1)
- Setting the opening A-D of the automatic slider (6) (see page 10 - fig.2)
- Increasing or throttling the driving speed
- In case of very moist material and thick spread layer, the guide plate (7) at the spreader
system (held by nut M8) can be removed (fig. 3).
7
Fig. 3: Spreader system
Disk setting in case of uneven spread pattern
Throwing vane rotation
The throwing vanes (8) can be adjusted as necessary within the adjustment slots (fig. 4).
Concentration of the material outside – set every other vane (8) in direction X
Concentration of the material inside – set every other vane (8) in direction Y
X
X
Y
Y
8
8
Fig. 4: Spreader disk
