20
15.0 CHANGE WHEELS
In case of a leaky or damaged wheel, the wheel should be repaired or replaced. This can be
done in the following manner:
1 Raise the Easy Spread ± 20 cm (8 ") from the ground. By means of the lifting
device of the tractor or with cables.
Make sure that the tractor is blocked well and cannot move on its own
accord!
Switch off the tractor before descending!
Make sure that the Easy Spread stands firmly on the ground and is
blocked against lowering before removing the tires!
2 Loosen the bolts (1) and nuts (2) of the designated wheel set.
!! The wheel set is now loose and can fall down, make sure nobody is under
the wheel set as the bolts and nuts are los loosened!!
3 Lower the wheel set. The entire wheel set is now loose.
4 To remove the wheel from the axle, loosen the securing screw (4) off the axle support.
The wheel and the axel support can now be removed from the axel.
5 Repair or replace the wheel.
Fig. 14
6 When the wheel is repaired or replaced it can be mounted again.
7 Mount he wheel and the axle support on to the axle. Secure the axle support by
tightening the screw (4)
8 Slowly rais the axle support on to the bolts. Make sure the slot hols are pointed
upwards.
9 Tighten the nuts (2) and bolt (1).
!! Make sure the nuts and bolts are tightend properly !!
10 Now slowly lower the Easy Spread on to the ground. The Easy Spread is now ready
for use.
