14
9.0 START/STOP
PROCEDURE
The start procedure is
VERY
important. If this procedure is not executed as described below, it might
result in serious damage to the subsoil.
The start procedure is as follows:
1. Check the Extreme Clean II for loose components and look whether all components function
properly.
!! If loose components are observed or components do not function properly, the
problems must be solved before using the Extreme Clean II!
2. Drive to the spot where the processing should take place.
!! Make sure that the tractor is blocked well and cannot move on its own accord!
!! Switch off the tractor before descending!
3. Allow the machine to sink until it is standing with the wheels on the ground.
4. Adjust the forcefulness as discussed in chapter 5.
5. Adjust the tractor engine to around 1200 rpm.
6. Connect/mount the PTO and increase the PTO revs to the maximum permitted level.
7. Engage the tractor in the correct gear.
8. Shift the tractor to a forward movement and adjust the speed to the maximum of 12
km/h (7.5 mph).
Stopping occurs as follows:
1. Let the tractor come to a standstill.
2. Decrease the engine revs to 1200 rpm.
3. Disconnect the PTO.
4. Lift the machine.
5. Drive to the next location and start the operation as described above.