26
16.4.2.
MINI NEEDLE TINES.
Mini Needle (solid) tines need another adapter block. The two studs D ( fig 14, right) fit a 12 mm (
½”) hole C of the standard machine tine head.
Per adapter block we have 3 rows with each 8 holes. So per block we can mount 24 mini needle tines.
If a full mounted block damages the turf, reduce the number of tines, like is shown in I, II and III.
Also try adjusting the working depth.
All tines are fitted with grub screws B. The grub screws of the centre row can only be accessed when
the outer row has been taken out.
Do not use and “kick” action. Adjust the machine at 90 degrees. The ( drilled) marks should all face
to one side of the machine.
The part number for the complete block , without tines, is 9990214 (6 needed for a full set).
The part number for the solid tine is 9990054 (144 needed for a full set).
-----ooooo-----
Fig.14.