19
10. Slide the new knives (6) including the bushes (7) over the axle.
11. Mount the bush (5).
12. Mount the nut (4) and tighten it.
13. Mount the bearings (3).
14. Return the axle under the machine.
15. Slowly lower the machine in a controlled manner.
16. Mount the axle in the machine and tighten it with the bolts (1) and nuts (2).
17. The machine is ready for use once again.
15.0
OPTION: ROLLER WITH LARGE KNIVES
If required, an axle with large disks is available for the Verti-Knife
®
in order to cut at a
greater depth. This axle’s article number is 216.116.002.
1
1
2
The procedure for mounting this axle is as follows:
!!
Watch out: the knives are sharp !!
!!
NEVER crawl under the machine !!
1. Remove the bolts and nuts (1) at both sides of the two axles.
2. Carefully lift the machine until the axles are completely free.
3. Pull the axles from under the machine and secure them against rolling away.
4. Place the new single axle including the new bearings and the large
disks under the machine and secure these against rolling away.
5. Slowly lower the machine in a controlled manner.
6. Mount the axle in the machine and tighten it with the bolts and nuts (2).
7. The machine is ready for use.
Please refer to Chapter 5.0 for adjusting the working depth. Please refer to the
technical data for the maximum working depth.
