Motion
Meter
High Speed Video Camera
_____________________________________________________________________________
9400-0024 Rev. G
2-5
OPERATOR'S INSTRUCTIONS
2.4.4
The Settings Menu
This menu shows the default settings for the Settings menu.
The alternate selections are shown to the right in Figure 2-5.
Select this menu by
pressing the Menu button
once in Live mode. Initially
the first line is active; press
the SEL button to go to the next line. Press
the + or – button to change the selection.
The settings are as follows:
Figure 2-5 The Settings Menu.
Master/Slave.
This determines whether the camera will be a Master or a Slave when connected.
Must be set to Master for normal operation.
Digital In.
Normally OFF. This input can accept a Phase Lock In (for Slave operation) or an
Event Marker input.
Digital Out.
This outputs a Strobe signal or a Phase Lock Out signal.
Gamma.
Normally ON, this turns the Gamma OFF.
LCD Bright.
This sets the brightness of the viewfinder. This does not affect the Video Out signal.
NTSC/PAL.
Sets the video standard output for the Video Out signal.
2.5 Input and Output Connectors
2.5.1
Power
The camera requires 12 volts DC at 2 Amps. The power connector is a DIN 3 pin
connector. There is no Power ON/OFF switch on the unit; this function is located on
the power cord.
2.5.2
Digital in
This input can be selected on the Settings menu to receive an Event Marker input
signal, or a Phase Lock In signal.
2.5.3
Digital Out
This connector can be selected on the Settings menu to output a Strobe signal or a
Phase Lock Out signal.
2.5.4
Trigger
The Trigger function is always enabled during record. This is a BNC connector.
Set the Trigger Point to determine the number of frames before and after the event.
Set the triangle up for a rising input signal, and down for a descending input signal.
2.5.5
Video Out
The Video Out BNC connector outputs an NTSC or PAL signal of live images (Live
Mode) or images from the image memory (Playback Mode) to an external monitor,
VCR or a computer with a video capture board.
