Red
CONNEX
TM
AN-80i
User
Manual
70-00072-01-04b
Proprietary Redline Communications © 2007
October 31, 2007
Page 40 of 94
changes to the community settings you must also click the Save Comm button in the
SNMP Configuration screen.
3.10.2 Change SNMP Trap Configuration
Each of the eight entries in the SNMP Traps Management table may be changed
individually. Click the Chg button to modify the settings for the adjacent entry.
Figure 17
:
Web - SNMP Trap Configuration Screen
Index
: Display the table position number for this entry. Position 0 is the first entry.
IP Address
: Enter the IP address (IPv4) associated with this SNMP alarm.
Port
: Enter the destination port address associated with this SNMP alarm.
Community Name
: Enter the SNMP community name for this entry.
Change Trap
: Click the Change Trap button to copy these settings to the community
settings table. This action does not permanently save changes. To save changes to the
SNMP trap settings you must click the Save Traps button in the SNMP Configuration
screen.
