Red
MAX
™
Subscriber Modem
User Manual
70-00057-01-01-DRAFT
Proprietary Redline Communications © 2006
December
13,
2006
Page 46 of 60
5.3.13 set - Set Commands
The set mode can be used to directly modify all available subscriber parameters.
The parameters listed in this table do not have a separate mode, and can openly be
modified by the set command.
Enter a new value for one or more fields in mode.
set [Enter]
Display all fields.
Modify selected field(s).
set [mode] [field] [value] [value] [field] […] <ENTER>
Table 22: CLI - set - Modify Subscriber Parameters
Command
Description
dhcpRelayAgent
Use this setting to enable or disable the DHCP relay setting.
0 -- Disable DHCP relay agent.
1 -- Enable DHCP relay agent.
ethernet
Use this setting to modify the Ethernet port auto negotiation, link
speed, and duplex settings.
AutoNegEnabled
<value>
0 -- Disabled
1 -- Enabled.
LinkSpeed
<value>
0 -- 10M
1 -- 100M.
LinkDuplex
<value>
0 -- Half
1 -- Full.
managedSS
The managedSS command allows you to configure the subscriber
for independent operation, or enable management using the
RedMAX EMS system. The managedSS parameter is controlled
from root mode. The following table lists all commands available
for managedSS.
0 - Disable remote management.
1 - Enable remote management.
sysContact
Enter device administration contact information (255 chars max.).
sysLocation
Enter the device location (255 characters max.).
sysName
Enter the device name (255 characters max.).
