AN-30 System User Manual
AN-30T
AN-30T
BTS Site A
AN-30T
AN-30T
BTS Site A
BTS Site B
AN-30T
AN-50
Base Station Controller Site
BTS Site B
Base Station Controller Site
AN-30T
AN-50
Figure 16 Typical PTP ‘multi-hop’ configuration
9.2.
Command Line Interface
The command line interface is used to configure the T1/E1 capabilities via the AN-30’s
console port or through a telnet session. The command set is divided into 5 categories,
C
ontrol, General, Serial Interface, DS0 Bundle, and Statistics
. The General, Serial
Interface and DS0 Bundle categories supports 3 distinct operations, a
get
operation, a
set
operation and a
show
operation
.
The
tdm get
operation is used to retrieve the specified parameter value from a running
configuration of an active system.
The
tdm set
operation is used to modify the specified parameter value in the temporary
configuration.
The
tdm show<category>
operation is used to list all parameter values of the specified
command category for either the running configuration or the startup configuration.
All commands conform to the following syntax:
<command operation> <command> <command target> <parameter value>
The
<command target>
field, is only used by the
Serial Interface
and
DS0 Bundle
category of commands:
The
<parameter value>
field is only required when issuing a
tdm set
operation.
Page 44 of 80
Redline Communications
…..solving the first mile challenge