AN-30 System User Manual
Set/Get Operations
The general set/get operations have the following syntax:
tdm set <command> <parameter value>
tdm get <command>
The
get
operation returns values from running configuration, the
set
operation applies to
the temporary configuration. The changes made by
set
operation become active only after
the
tdm save
command is successfully executed.
The general command set is as follows:
hostname
ipaddr
ipmask
gateway
vlandata
vlanvoice
clock
syncon
idlecode
key
line
softver
fanstate
The parameter for each command is valid only if used with the
set
operation.
hostname, params: HOST
The hostname of the T1/E1 module.
ipaddr, params: IP address in format a.b.c.d
The IP address of the T1/E1 module.
The TDM module in the AN-30 is uniquely identified by its IP address. The IP
address is used with the
destip
command to direct TDM traffic to a specific AN-30
end point.
By uniquely addressing the TDM module within the AN-30 it is possible to relay
traffic through an intermediate set of AN-30s without terminating the TDM stream.
The intermediate AN-30s can therefore act as a repeater while also providing Add
Drop Multiplexing (ADM) functionality as shown in Figure 16.
ipmask, params: IP mask in format a.b.c.d
The network mask. Not implemented for
tdm_set
operation
Page 49 of 80
Redline Communications
…..solving the first mile challenge
