20 Willow Springs Circle
• York, PA 17406 • USA • T +1 717 767 6511 • F +1 518 877 8346 • customer.service@redlion.net
www.redlion.net
QUICK START GUIDE
EnterprisePro
TM
Router
CDMA R-3300 or R-1300
UNPACKING INSTRUCTIONS
1
Unpack the Red Lion Wireless unit and verify the following
components are enclosed for the EnterprisePro
TM
Router
(Figure A).
Figure A
: Package Contents R-3300 or R-1300:
Not Shown: Antenna included with model R-1300 or R-3300
Non-US
power supplies require customer-supplied power cord to connect power to
AC power outlet
2
If any items are missing, please contact Red Lion
Wireless at +1 800 489 7781.
3
Optional item to use for Out-of-Band (OOB) Management
function of the Red Lion Wireless modem: Cisco DB9 to
RJ45 Console Cable.
CDMA MODELS R-3300 OR R-1300
R-3300-S (SPRINT); R-3300-V (VERIZON), R-3300-US (US
CELLULAR)
– UNITS ARE CARRIER SPECIFIC
1
The unit will need to be activated with a cellular carrier. If
not, contact your cellular carrier and provide them with the
ESN number located on the bottom label of the unit.
2
Attach the antenna.
3
Attach power supply connector to the “barrel” power outlet
on the back of the unit and connect power supply plug to an
AC power outlet. Verify the POWER (green) LED is lit to
indicate that the unit is receiving power.
5
Please allow 2-4 minutes for the unit to recognize the
cellular data card and connect to the cellular network. When
this has occurred the Signal Strength LEDs should light up
from 1 to 4 LEDs. Red Lion Wireless recommends 2 bars or
greater for proper functionality of the unit. If signal strength
is showing 1 LED or showing the top and bottom LEDs
flashing (1 and 4 positions), please refer to the User Manual
at
6
Connect to the Ethernet RJ45 port for network connectivity.
ACCESSSING THE GRAPHICAL USER INTERFACE (GUI)
1
Connect PC to EnterprisePro
TM
Router
The Ethernet Port on the EnterprisePro
TM
Router
is “auto-
sensing”, which means a straight through or cross-over
cable can be used to connect to the Red Lion router.
Connect a CAT-5 Ethernet cable between the local PC and
the unit’s Ethernet port. Verify the link LED is lit.
2
Setup PC IP Address
For assistance with configuring your PC, see the appropriate
Microsoft Windows support webpage listed at:
PC to Ethernet Interfaces
Se
lect “Use the following IP address” and fill in the blank
fields with the information below:
Ethernet 0
Ethernet 1
IP address
192.168.0.2
192.168.1.2
Subnet mask
255.255.255.0
255.255.255.0
Default gateway
192.168.0.1
192.168.1.1
Preferred DNS
192.168.0.1
192.168.1.1
3
Access Graphical User Interface
Open a web browser & enter the following in the
address bar:
Ethernet 0:
Ethernet 1
LOGIN INSTRUCTIONS
• User Name enter:
admin
(lowercase letters)
• For Password enter:
six digit serial number of unit
(lowercase)
Upon successfully logging in you will see the following screen
.
Figure B
: GUI:
You are now connected to the Management GUI. If you should
see anything other than the GUI screen shown, please refer
to the EnterprisePro
TM
Router User Manual located at:
(Front)
Power Supply
(United States)
Power Supply*
(International)
Ethernet Cable
(
6’ CAT 5E 568B)
