background image

US-21

BCZ3050S/T/SW

U
S

The EPA (U.S. Environmental Protection Agency), CARB (California
Air Resources Board), Environment Canada and RedMax are
pleased to explain the emissions control system's warranty on your
2009 and later small off-road engine. In U.S. and Canada, new
equipment that use small off-road engines must be designed, built,
and equipped to meet the applicable Federal or Californian stringent
anti-smog standards. RedMax must warrant the emissions control
system on your small off-road engine for the period listed below
provided there has been no abuse, neglect or improper maintenance
of your equipment. Your emissions control system may include parts
such as carburetor, ignition system, catalytic converter, fuel tank,
filters and other associated components. Also, included may be
hoses, belts, connectors, sensors, and other emission-related
assemblies. Where a warrantable condition exists, RedMax will repair
your small off-road engine at no cost to you including diagnosis, parts
and labor.

MANUFACTURER'S WARRANTY COVERAGE

This emissions control system is warranted for two years or if the
product qualifies for a longer warranty period resulting from the type
of use, that period shall prevail. If any emissions-related part on your
equipment is defective, the part will be repaired or replaced by
RedMax.

OWNER'S WARRANTY RESPONSIBILITIES

As the small off-road engine owner, you are responsible for
performance of the required maintenance listed in your Owner's
Manual. RedMax recommends that you retain all receipts covering
maintenance on your small off-road engine, but RedMax cannot deny
warranty solely for the lack of receipts or your failure to ensure the
performance of all scheduled maintenance. As the small off-road
engine owner, you should however be aware that the RedMax may
deny you warranty coverage if your small off-road engine or a part
has failed due to abuse, neglect, or improper maintenance or
unapproved modifications.

You are responsible for presenting your small off-road engine to a
RedMax distribution center or service center as soon as the problem
exists. The warranty repairs should be completed in a reasonable
amount of time, not to exceed 30 days. If you have any questions
regarding your warranty coverage, you should contact RedMax at 1-
800-291-8251 or via e-mail at service@redmax.com.

WARRANTY COMMENCEMENT DATE

The warranty period begins on the date the engine or equipment is
delivered to an ultimate purchaser.

LENGTH OF COVERAGE

RedMax warrants to the ultimate purchaser and each subsequent
owner that the engine or equipment is designed, built, and equipped
so as to conform with all applicable regulations adopted by EPA and
CARB, and is free from defects in materials and workmanship that
causes the failure of a warranted part for a period of two years.

WHAT IS COVERED

REPAIR OR REPLACEMENT OF PARTS

Repair or replacement of

any warranted part under the warranty must be performed at no
charge to the owner at a warranty station. Warranty services or
repairs will be provided at all RedMax distribution centers that are
franchised to service the subject engines. Throughout the emissions
warranty period of two years, RedMax must maintain a supply of
warranted parts sufficient to meet the expected demand for such
parts.

WARRANTY PERIOD

Any warranted part that is scheduled for

replacement as required in the maintenance schedule, is warranted
for the period of time prior to the first scheduled replacement point for

that part. If the part fails prior to the first scheduled replacement, the
part will be repaired or replaced by RedMax at no cost. Any such part
repaired or replaced under warranty is warranted for the remainder of
the period prior to the first scheduled replacement point for the part.
Any warranted part that is not scheduled for replacement as required
in the maintenance schedule, is warranted for two years or if the
product qualifies for a longer warranty period resulting from the type
of use, that period shall prevail. If any such part fails during the period
of warranty coverage, it will be repaired and replaced by RedMax at
no cost. Any such part repaired or replaced under the warranty is
warranted for the remaining warranty period. Any warranted part that
is scheduled only for regular inspection in the maintenance schedule
will be warranted for a period of two years. A statement in such
written instructions to the effect of "repair or replace as necessary"
will not reduce the period of warranty coverage. Any such part
repaired or replaced under warranty will be warranted for the
remaining warranty period.

DIAGNOSIS

The owner must not be charged for diagnostic labor that

leads to the determination that a warranted part is in fact defective,
provided that such diagnostic work is performed at a warranty station.

CONSEQUENTIAL DAMAGES

RedMax is liable for damages to

other engine components proximately caused by a failure under
warranty of any warranted part. 

EMISSION WARRANTY PARTS LIST

1. Air-induction system*
2. Fuel system*
3. Ignition system*
4. Fuel tank, cap and lines as applicable*
*some components only covered up to point specified by
maintenance schedule

WHAT IS NOT COVERED

All failures caused by abuse, neglect or improper maintenance are
not covered.

ADD-ON OR MODIFIED PARTS

Add-on or modified parts that are not exempted by CARB or EPA
may not be used. The use of any non-exempted add-on or modified
parts will be grounds for disallowing a warranty claim. RedMax will
not be liable to warrant failures of warranted parts caused by the use
of a non-exempted add-on or modified part.

HOW TO FILE A CLAIM

If you have any questions regarding your warranty rights and
responsibilities, you should contact your nearest authorized servicing
dealer or contact RedMax at 1-800-291-8251 or via e-mail at
service@redmax.com.

WHERE TO GET WARRANTY SERVICE

Warranty services or repairs are provided through all RedMax
authorized servicing dealers.

MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION-
RELATED PARTS

Any replacement part may be used in the performance of any
warranty maintenance or repairs and must be provided without
charge to the owner. Such use will not reduce the warranty
obligations of the manufacturer.

MAINTENANCE STATEMENT

The owner is responsible for the performance of all required
maintenance, as defined in the operator's manual.  

FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY

STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS

Summary of Contents for BCZ2450S
























Reviews: