34
9. Maintenance
English
■
REFILLING TRIMMING LINE (MA1)
1. For replacement line, use a diameter of .095in
(2.4mm). The spool is capable for a line upto 20ft
(6m) on the 4” head. Avoid using a larger line as it
may cut down the trimming performance.
For safety reasons, do not use metalreinforced
line.
2. Pinch the slotted area on the both sides of the spool
housing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Fold new
line so that one half line is 4.7in.(12cm) shorter than
another half. And then, hook bended end in the slot
of the spool.
4. Wind up the line in the correct direction as indicated
on the spool.
5. Hook each end of the line in the slot on the edge of
the spool, and then put the ends through the eyelets
on the housing. Make sure that the spring and the
washers are in place.
6. While holding the spool against the housing, pull the
line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook on
the housing, press the cap against the housing until it
clicks.
• Make sure that the engine has stopped and is
cool before performing any service to the
machine. Contact with moving cutting head or
hot muffler may result in a personal injury.
■
AIR FILTER
• The air filter, if clogged, will reduce the engine
performance. Check and clean the filter element in
warm, soapy water as required. Dry completely
before installing. If the element is broken or shrunk,
replace with a new one. (MA2)
(1) air filter
■
FUEL FILTER
• When the engine runs short of fuel supply, check the
fuel cap and the fuel filter for blockage. (MA3)
(1) fuel filter
WARNING
WARNING
MA1
(1)
MA2
(1)
MA3
