WELDED FRONT SUPPORT
AA
3/8" CARRIAGE BOLT 2.25" LONG
FIGURE 10.1
FIGURE 10.2
3/8" FLANGE NUT
STEP 1
: With the Stand built, find the Welded Front Support AA. Slide the Front Support over the front of the
stand as shown in Figure 10.1. Make sure the wider top flange is facing up as shown in Figure 10.2. Once the
Support is pushed all the way in place the cross bar should hit with the front of the stand. With the Support in
place secure it with a 3/8" x 2.25" long carriage bolt, you will use one of the (2) holes as shown in Figure 10.2. If
your stand has a channel across the front you will use the farther one and if your stand has a tube at the end of it
you will use the closer one. Install the bolt going from the top down and secure on the bottom side with a 3/8
flange nut finger tight. Do this on both sides to keep in place during assembly.
-3-
