10
WARNING: DO NOT USE THE UNIT IF YOU THINK IT MAY BE FROZEN,
AS THIS COULD RESULT IN SERIOUS DAMAGE TO THE UNIT.
WAIT UNTIL YOU ARE SURE THAT IT HAS COMPLETELY
THAWED OUT BEFORE YOU SWITCH ON.
Basin
Check that the power is switched on at the mains isolator switch.
Turn on the hot water tap
FULLY
. If you do not turn the tap on fully, you will find that the
temperature of the water will vary. The hot water temperature will have been set using the
service valve (diagram 5). See “Selecting my power level” section
If the unit has been used recently, run the water through for a few seconds to let the
temperature settle down, we advise you DO NOT enter the water flow during this time.
WARNING: YOU MAY INITIALLY GET A SHORT BURST OF VERY HOT
WATER FROM THE UNIT.
If a second tap connected to the unit is also turned on, the hot water will be shared between the
two and so the flow will drop.
When you have finished do not switch off the power if you are going to use the unit again shortly
Shower
Check that the power is switched on at the mains local isolator switch.
Turn on the hot (or “flow”) tap
FULLY
(diagram 9). Ensure unit is set to “High” setting.
If the unit has been used recently, run the water through for approximately 20 seconds to let the
temperature settle down, we advise you DO NOT enter the water flow during this time.
WARNING: YOU MAY INITIALLY GET A SHORT BURST OF
VERY HOT WATER FROM THE UNIT.
Turn on the cold (or “temperature”) tap, if necessary, to adjust the temperature of the water.
Make sure that no other outlets connected to the unit are used whilst you are in the shower, or
the water flow will drop suddenly.
When you have finished do not switch off the power if you are going to use the unit again shortly
It is important to clean the shower handset regularly (see page 11).
In order for the Powerstream-Eco to function correctly, the “Redring Mixer Kit” must be used.
The kit, Cat No. 85-793620, comes complete with full accessories including a 3 position
multi-function shower handset.
SELECTING POWER LEVEL
The Powerstream-Eco has four power levels to choose from changing these allows the level of heat
to be changed in discreet steps. The user can set these easily by rotating the central knob to the
desired setting (see diagram 8). In general, the lower the power level is the lower the flow rate will
be, to achieve the same temperature. The control can be set up using the High setting and then the
temperature reduced by selecting a lower power level i.e. Set unit up for showering and then select
Eco/medium when using the unit to wash your hands.
CAUTION:
The flow switch built into the Powerstream-Eco will switch off the heat if the flow rate is
set too low. This will be indicated by the neon light going out.
HOW TO USE YOUR
POWERSTREAM-ECO
