POWERSTREAM Ascari -
p. 20 -
2.9.1 Automatic/ Manual Operation
The boiler must be set to Manual operation as follows:
Press and hold the Auto/Man button. The display will show
Au
or
Man,
press the Auto/Man button again for a
short period to toggle the display so that it shows
Man.
With the correct display showing, press and hold Auto/
Man for 3 seconds to return to normal operating mode.
2.10 - Pump Speed
The boiler is factory set at pump speed 3, for lower pump speeds the selector in the centre of the pump may be
turned to 1 or 2 using a large flat bladed screwdriver.
2.11 - Troubleshooting
The boiler has many selectable options. Please ensure the correct selections are made for the type of installation
you have made. If you have selected the use of a room thermostat, or hot water cylinder, the boiler will not operate
until these devices are connected.
•
The boiler indicates a boiler fault by flashing
in front of the symbol
"
°C
"
, and
or
in front
of the symbol
"
bar
"
Please call the Redring Customer Service department – see Servicing section.
•
FLASHING SEGMENTS in front of bar – indicate the system pressure has fallen below the minimum
operating pressure.
•
check if water has discharged from the pressure relief valve. If so call a Redring service agent.
•
check for leakage in the system.
Once the fault has been cleared the boiler will turn on again if the system is filled and pressurised to over 0.5
bar.
2.12 - Servicing
It is recommended that the Boiler be installed and serviced regularly by a REDRING service agent to ensure
continual trouble-free operation. For details of service agents in your area please contact:
Applied Energy Products Ltd.
Morley Way, Woodston
Pe
ter
borough PE2 9JJ
United Kingdom
Registered Office : Pe
ter
borough PE2 9JJ
Registered in England No. 306008
VAT Reg. No. GB 287 1315 50 038
Telephone Applied Energy technical service on 0844 3727766
or contact on techfax 0844 3727767.