3.
(optional) HD anti-vibration plate: Push Soft Bobbins into the top plate, then seat plate on bobbins. Run 1-2
small zip ties through the center slots in the HD plate passing through the top plate, CCD plate (if used), and
back into the HD plate. Tighten zip ties until they take up slack but do not compress bobbins. Clip excess
length. This step will insure your plate will not separate from the frame in a crash.
Summary of Contents for STRIDER 250
