STRONG DESIGNS RW EDGE 540V3 30CC
11
Rudder Servo and Pull-Pull
•Locate the pull-pull hardware - - one set of
links should already be installed to the rudder.
•Route the pull-pull cables from the slots in the
rear of the fuselage to the rudder servo tray. At
the rudder, slide a crimp onto the wire and loop
the cable thru the link and back into the crimp
with a loop as shown to hold the end in place
for each side.
DO NOT CRIMP YET!
NOTE:
Make sure the ball link is threaded in the
center of the adjustment range (about ¾ of the
thread) to allow even adjustment.
•Drop the servo into place and drill for the
servo screws with a 1/16” drill bit.
•Remove the servo and thread a servo screw in
and out of each hole. Then apply 2 drops of thin
CA to each and allow the CA to soak in and fully
cure.
•Install the servo with the output to the front of
the fuselage and center using the radio.
• Install the links to your servo horn using the
included hardware. Then, install and crimp the
cables in place on the servo end as shown - -be
sure to leave the excess on the rudder end.
NOTE:
The cables should cross inside the
fuselage as shown when installed to the servo
horn.
