STRONG DESIGNS RW EDGE 540V3 30CC
14
Engine Installation
•The firewall comes marked for the DLE 35RA
and DLE 40 twin.
NOTE:
The DLE40 Twin will NOT fit inside the
cowl without the plug caps showing. A better
choice is the VVRC 40cc Twin with the ¼-32
plugs.
•If using a different engine, align your motor’s
mounting template with the centering marks on
the firewall and secure in place with tape if
needed.
From the Pro:
Cutting toward the center of the
template as shown
will make alignment
easier and more
precise.
•Once aligned, drill the mounting holes with the
proper size bit for the mounting bolts and
remove the template.
•Next, temporarily mount the motor in place to
mark for the throttle linkage, fuel lines, and any
ignition cable routing.
•Check the engine’s spacing by measuring from
the firewall to the front of the engine’s prop
hub. Proper spacing is 6 3/8" (162mm) from
the firewall.
--The DLE stock standoffs work perfectly.
•Next determine where you will need to mount
the throttle servo to properly align with the
carburetor. You may find you need to rotate
the carb or modify the throttle arm for proper
geometry.
